(You should add 2 new SIP trunks to your system, one will register to gw1.sip.us and the other to gw2.sip.us for redundancy)
ADD NEW SIP TRUNK (if you happen to have multiple SIP.US trunks and still don't want to use the module, put a unique identifier at the end of the Trunk Name, such as the last 4 digits of your trunk number, so you can easily identify which trunk is which on the system)
Since this is an 'image above' you can copy/paste this section of the GW1 PEER Details (change trunk number and trunk password in all places):
type=peer
insecure=port,invite
host=gw1.sip.us
port=5060
dtmfmode=rfc2833
canreinvite=no
disallow=all
allow=ulaw
qualify=yes
qualifyfreq=30
nat=yes
trustrpid=yes
fromdomain=gw1.sip.us
username=[trunk number - no brackets]
secret=[trunk password - no brackets]
context=from-trunk
rfc2833compensate=yes
session-timers=refuse
Submit changes and Apply Config Changes, then go right back and add the second SIP.US SIP trunk:
Since this is an 'image above' you can copy/paste this section of the GW2 PEER Details (change trunk number and trunk password in all places):
type=peer
insecure=port,invite
host=gw2.sip.us
port=5060
dtmfmode=rfc2833
canreinvite=no
disallow=all
allow=ulaw
qualify=yes
qualifyfreq=30
nat=yes
trustrpid=yes
fromdomain=gw2.sip.us
username=[trunk number - no brackets]
secret=[trunk password - no brackets]
context=from-trunk
rfc2833compensate=yes
session-timers=refuse
Finally, create your outbound route:
Submit and Apply Changes and both trunks should be registered. You can check your trunk status on the SIP.US Control Panel under the main SIP Trunking tab and then click on 'Trunks'. You should see the following:
Your system should now be configured for outbound calling.
To configure inbound calling for your DIDs, be sure to include the '1' in front of the telephone number, ex: 15612322200 when adding the Inbound route!
Comments