This guide will walk you through registering one of VTEC's Eris Terminals to a SIP.US trunk.
1. Get your Eris Terminal plugged in and a connected to your network.
2. Register an endpoint (whether that be an Eris Terminal or a Handsfree set) by following the on screen instructions.
3. On your registered endpoint, navigate to Menu --> Status --> Network to find the IP address of the Eris Terminal.
4. Open a web browser on a computer within the same local network as the Eris Terminal and enter the IP address into the address bar.
5. Use the credentials admin//admin to access the Admin Gui of the Eris Terminal.
6. Navigate to the System tab and enter the following information:
Under General:
Account label: SIP.US
Display Name: SIP.US
User Identifier: Trunk #
Authentication Name: Trunk #
Authentication Password: Trunk Password
Dial Plan: x+P|(:1)xxxxxxxxxx
Under SIP Server:
Server Address: gw1.sip.us
Under Outbound Proxy:
Server Address: gw1.sip.us
Under Call Identity:
Make the 1st priority From followed by RPID then PAI.
Under Audio:
Top priority should be G.711u followed by G.729a/b. The rest should be set to 'None'
Under NAT Traversal:
Check 'Enable Stun'
Server Address: stun.sip.us
Port:3478
Check Enable STUN Keep-Alive
Keep-Alive Interval (secs): 30
7. In your SIP.US account, you will need to navigate to SIP TRUNKING --> SIP TRUNKS, click on the 'Modify trunk' button for the trunk you are registering to, and set 'Contact Override' to 'NO'. Any DIDs on this trunk will be routed to this 'Account' within the Eris system. You can route which accounts ring which endpoints within the GUI under 'Account Assignments'. If you need to have multiple phone numbers ring separate endpoints, you will need an account registered to a unique trunk for each.
8. Congratulations, your trunk should now be registered and your Eris System should make inbound and outbound calls!
Comments